help w/ hellas

[double d 39]

got comet 500s. i have hooked up everything acording to the diagram exept for the ground for the dash switch. do i need that for everything to work? what are some problems or things i might not have done right?

thanks

[97ScoobyL]

is you relay ground running through the switch? dont have the diagram on me but or my hellas have a signal hot wire out the the relays,which is how my directions are.

[double d 39]

i have everything set up right except the green high beam tap i think. the directions say to go to high beams, red, but some people say go to ground, blue. neither have worked for me. can some one post a pic of their engine bay and how they wired these?

[Bubba02sti]

http://i806.photobucket.com/albums/yy345/Rally_Subie/All%20Things%20subaru/rsmn.jpg

This is to set them up just on the switch alone... however if you wanted to set them up so they turn on with your high beams you take the teal wire and run that from the switch to the high beam wire for your head lights... use a wire tester... they arn't always the red wire... your best bet is to set it up like the diagram first to make sure your lights are working...

yes all your grounds need to be connected

Edit: Ill take a pic of my motor bay so you can see how its ran on mine...

Edit x2:

Its a little messy right now cause im in the middle of replacing my radiator and i haven't gotten around to taking my dash apart and running the wires that way... any way if you follow the diagram at the top you should be fine...

http://i806.photobucket.com/albums/yy345/Rally_Subie/All%20Things%20subaru/DSCF1853.jpg

http://i806.photobucket.com/albums/yy345/Rally_Subie/Mishimoto%20Radiator%20Replacement/DSCF1832.jpg

[double d 39]

ok, thanks! 2 questions though, where did you ground the dash switch two? and do you need to ground the relay to the battery?

[Bubba02sti]

I just used a space in the dash that was metal for the switch and i used the the fender by the battery for the relay ground

[ricetiva]

on my set up, i grounded the relay to the batter along with my lights, and for my switches i used a nut and bolt that was under my dash.